OBD-II / CAN Interface

This also arrived recently, ordered from dakota digital, this little gem is a one of it's kind on the market.
It allows new canbus engines fitted to non-canbus cars, The ability to run the old analogue clocks.
It also allows you to run the analogue speedometer.
But this means that you need to have swapped over the wheel speed sensors and abs ecu and actuator.

Otherwise you could just swap the rear wheel speed sensors & the abs ecu will send a canbus
packet that states the vehicles speed and the can interface with convert this to analogue, also handy
if your new engine & matching gearbox doesn't have a speed sensor or prop speed sensor.

This unit does need to be calibrated to the vehicles existing clocks but takes 5-10 to set.
As it gives out a constand 60mph & 2000rpm test signal for you to set them with.